Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety Instructions
Electrical requirements:
Always switch off and disconnect the power supply
to the appliance before installation, when not in use,
before cleaning and maintenance/service.
This appliance should only be connected to the mains
electricity supply by a qualified electrician. Hardwire
the appliance into a suitable power supply with correct
voltage and sufficient power capacity. Refer to the
rating label on the appliance for voltage and wattage
requirements.
Connect the appliance to a circuit protected by an
appropriate RCD (Residual Current Device).
Under no circumstances put a plug on the cable.
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• Not suitable for outdoor use.
• Caution: Hot surfaces
• DO NOT immerse the appliance in water.
2
CU487-CU488_EN_A5_v2_20230519.indb 2
DANGER OF HIGH VOLTAGE!
2023/5/19 17:30:56
Publicidad
