Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON
to relieve water pressure.
DO NOT use pipe dope
or thread sealant on drain
assembly, or any plastic
threaded components.
1) Insert supply lines (M) and threaded
rods (L) through escutcheon (K)
and sink hole.
M
2) Place rubber washer (N), metal
washer (O) onto threaded rods (L).
Secure with nuts (P).
L
N
O
P
1
Note: Hoses removed for clarity.
3) Apply plumber putty to underside
of flange (L).
4) Insert flange (L) into drain opening.
From below, attach drain body (Q)
with gasket (M) and washer (N) to
flange (2-3 turns until hand tight).
L
K
Note: Make sure drain cavity (on
drain body) faces rear of sink.
5) From below, tighten flange nut (O)
to secure drain body (Q).
DO NOT overtighten.
2
Note: Make sure flange is centered in
drain opening.
L
L
OPTIONAL
1
2
M
N
3
Q
O
Q
3
6) Insert stopper (K) into flange (L)
and rotate to proper position.
K
K
Non Removable
L
K
Note: Stopper can be installed
removable or non-removable
determined by eye hole position.
7) Insert pivot rod (T) into drain body
(Q) against gasket (P) and inner seat
(R). Install outer seat (S) against
pivot ball and secure assembly by
tightening retaining nut (U).
T
P
R
Q
Note: Pivot rod passes under stopper.
8) Insert lift rod (J) into back of faucet
body (E). From below, attach clevis
strap (W) to lift rod (J). Tighten
thumb screw to secure.
1
E
J
2
W
Removable
Removable
S
U
J
Publicidad
