Publicidad
Idiomas disponibles
Idiomas disponibles
Be sure no one other than the operator is standing near the lawn mower
while starting engine or operating mower. Never run engine indoors or
in enclosed, poorly ventilated areas. Engine exhaust contains carbon
monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose
clothing away from any moving parts on engine and lawn mower.
To Start Engine
1.
Push the primer three times. See Figure 12. Do not prime to restart a warm
engine.
NOTE: If you push the primer too many times, excessive fuel will flood the
carburetor and the engine will be difficult to start.
2.
Standing behind the mower, squeeze the blade control handle against upper
handle.
3.
Holding these two handles together firmly, grasp recoil starter handle and
pull rope slowly until resistance is felt, then pull with a rapid, continuous, full
arm stroke. See Figure 12. Keeping a firm grip on the starter cord handle, let
the rope rewind slowly. Repeat until engine cranks. Let the rope rewind each
time slowly.
Rapid retraction of starter cord (kickback) will pull hand and arm toward
engine faster than you can let go. Broken bones, fractures, bruises or
sprains could result.
To Stop Engine
1.
Release blade control to stop the engine and blade.
Wait for the blade to stop completely before performing any work on the
mower or to remove the grass catcher.
Using Your Lawn Mower
Be sure lawn is clear of stones, sticks, wire, or other objects which could damage
lawn mower or engine. Such objects could be accidently thrown by the mower in
any direction and cause serious personal injury to the operator and others.
The operation of any lawn mower can result in foreign objects being
thrown into the eyes, which can damage your eyes severely. Always
wear safety glasses while operating the mower, or while performing any
adjustments or repairs on it.
OPERATION
WARNING
WARNING
WARNING
WARNING
3
Using as Mulcher
For mulching grass, remove the grass catcher and allow the rear discharge door
to close the rear opening of mower. For effective mulching, do not cut wet grass.
If the grass has been allowed to grow in excess of four inches, mulching is not
recommended. Use the grass catcher to bag clippings instead.
Using Grass Catcher
You can use the grass catcher to collect clippings while you are operating the
mower.
1.
Attach grass catcher following instructions in the "Assembly" section. Grass
clippings will automatically collect in bag as you run mower. Operate mower
until grass bag is full.
2.
Stop engine completely by releasing the blade control. Make sure that the
unit has come to a complete stop.
3.
Lift discharge door and pull grass bag up and away from the mower to
remove the bag. Dispose of the grass clippings and reinstall the bag when
complete.
If you strike a foreign object, stop the engine. Disconnect the spark plug
wire, thoroughly inspect mower for any damage, and repair damage
before restarting and operating. Extensive vibration of mower during
operation is an indication of damage. The unit should be promptly
inspected and repaired.
13
3
2
Figure 12
WARNING
1
Publicidad
