Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1. SDS+ Hammer
2. Dust protection cap
3. Tool holder locking sleeve
4. Function mode selection
5. ON/OFF switch
6. Forward and reverse rotation
control
7. Battery pack
8. Battery lock
9. LED light
10. Battery charger
Prodcut especifications:
Rated voltage
Motor
No load speed
Functions
Type
Max. Drilling capacity
Sound pressure
LpA (KpA=3dB(A))
Sound power level
LwA (KwA=3dB(A))
Hammer drilling concrete
OPERATION
1. INSERTING OR REMOVING DRILL BIT IN SDS+
▶Clean and lightly oil the bit before inserting.
▶Insert the dust-free bit into the bit holder with a twisting motion until it latches.
▶The bit locks itself. Check the locking by pulling on the tool.
WARNING : Your Rotary Hammer Drill generates powerful forces to get your job done quickly and effectively. These forces may cause
inferior quality SDS bits to break and jam in the chuck. We therefore recommend that only high quality SDS bits be used with this
tool.
Retract back the bit holder locking sleeve (3) and pull out the bit.
2. ON/OFF SWITCH
Instruction manual
2
1
3
9
10
20V
Brush
0-850/min
2
SDS+
Wood 16mm, steel 10mm,
concrete 13mm
85dB(A)
96dB(A)
5.69m/s2 K=1.5m/s2
4
8
ref. 08373
ES
PT
6
EN
5
FR
7
Publicidad
