Publicidad
Idiomas disponibles
Idiomas disponibles
EMPTY DUST BOX (SEE FIG B2)
For more efficient operation, empty dust box
every 5-10mins. This will permit the air to flow
through the box better. To empty the dust box,
remove it from the dust extraction port, shake
out dust.
Fig. B2
USING THE DUST EXTRACTION VACUUM
ADAPTER (SEE FIG C1,C2)
Your sander is equipped with a dust extraction
vacuum adapter, which is designed for
collecting dust task. Connect the dust
extraction vacuum adapter into the hose of a
vacuum cleaner.
First please turn on the vacuum cleaner, then
turn on the sander. If you stop sanding, first
turn off the sander, then turn off your vacuum
cleaner.
Fig. C1
Page 10
OPERATION
Fig. C2
4. OPERATING THE SWITCH (SEE FIG D)
To start your sander, depress the protective
cover over the switch at the position marked"I".
To stop your sander, depress the protective
cover at the position marked "0".
Fig. D
5. FLUSH SANDING FACILITY
Your sander can sand flush on three sides of
the base plate which allows easy access to
corners and edges of mouldings.
6. ORBITAL SANDING
Your sander operates in small circular rotations
which allows efficient material removal. Operate your
sander in long sweeping movements across your
workpiece and even across the grain. For a finer
finish, always use a fine grain sand paper and only
move the sander in the direction of the grit and never
across the grain. Do not allow your sander to remain
in the same position otherwise you will remove
material and create an uneven surface.
Publicidad
