Publicidad
Idiomas disponibles
Idiomas disponibles
EN
EN
MAINTENANCE
VALVE ASSEMBLY
1. Place the control gun body in a vise or similar and
mount the valve. Then, fix the valve with the pins (2).
2. Put the torsion spring (3) into the gun body. Make sure
the spring pin fits into the housing located in the gun
body. Then, insert the supplied 14 mm long auxiliary pin
(4) for mounting purposes. This pin is located in the
equipment packaging.
3. Place the trigger (5)
4. With a hammer, insert the 22 mm long main pin (6) on
which the trigger will rotate. As you insert this pin, the
mounting auxiliary pin will be pushed out. When the
auxiliary pin is ejected, the 22 mm pin will remain in
its position.
FILTER DISASSEMBLY
The gun can be provided with a filter (optional). To check
its status or replace it, follow the procedure below:
1. Remove the "U" pin (1).
2. Pull out the swivel (2) and then remove the filter (3)
3. Check the filter and clean or replace it if necessary.
Insert the filter, mount the swivel and connect the hose.
6
896 854 R. 07/23
Samson Corporation • One Samson Way • N.C. 28778 Swannanoa USA • Phone (828) 686-8511 • Fax (828) 686-8533
1
3
5
1
4
3
2
6
2
Publicidad
