Ingersoll Rand 109XP Manual De Instrucciones página 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll- - Rand No. 50
Always use an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For U.S.A.- - No. C28- - 04- - FKG0- - 28
For International- - No. C28- - C4- - FKG0
Before starting the tool and after each two or three
hours of operation, unless the air line lubricator is used,
pour approximately 1.5 cc of Ingersoll- - Rand No. 50 Oil
into the air inlet.
Periodically, inject several drops of Ingersoll- - Rand
No. 50 Oil between the Ratchet Housing (30) and Ratchet
Yoke (34) to lubricate the Drive Bushing (33).
Model Drive
in.
109XP 3/8"
1099XP 1/2"
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested to ISO8662- - 7
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620kPa)
PLACING TOOL IN SERVICE
For the Gearing - -
Ingersoll- - Rand No. 28
For the Ratchet Housing
Ingersoll- - Rand No. 66
SPECIFICATIONS
Free Speed Recommended
Torque Range
rpm Ft- - lb (Nm)
300 10 to 60 (14 to 81)
300 10 to 60 (14 to 81)
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
HSound Level
dB (A)
Pressure
93.4
93.4
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
♦Vibrations
Level
2
Power m/s
106.4 2.7
106.4 2.7