Publicidad
Idiomas disponibles
Idiomas disponibles
Under the above-mentioned conditions, the automatic overload guard of the motor is
triggered, whereupon the current feed to the device is interrupted.
In such a case, please take the following steps:
1.
Switch the main switch to OFF. Disconnect the main plug from the AC socket in
order to avoid the risk of serious injuries and wait at least 60 minutes until the
overload guard has reset. Now tear off excess paper from the top of the shredder or
remove it.
2.
Reconnect the main plug to the AC socket and switch to REV. Pull the remaining paper
away from the shredding blades. If necessary, repeat this step.
Technical data:
Shredding type:
Size of cut:
Shredding capacity:
Feed width:
Input voltage:
Dimensions:
Noise level:
We declare that this device, with regard to its task of the destruction of documents, fulfils the
conditions defined for Security Level P-2 in accordance with DIN 66399.
P-2: Recommended for data media containing in-house data which should be rendered
illegible. Material particle area ≤ 800 mm² or strip width ≤ 6 mm, strip length unlimited.
Cleaning:
Danger! Unplug the power cord before cleaning. There is a risk of electric shock!
Warning! The blades of the device are very sharp! Danger of injury!
1. Empty the drip trays regularly.
2. Clean the drip trays and paper cutter with a slightly dampened cloth and possibly with a
mild detergent.
3. Remove any residue in the cutting holes with a suitable object. Make sure that while
cleaning the plug is pulled in order to avoid injuries.
Strip-cut
6 mm (paper)
6 pages DIN A4 (80 g)
approx. 220 mm
220-240 VAC, 50 Hz, 0,9A
approx. 326 x 115 x 71 mm
approx. 72 dB
The CE Mark on the device confirms conformity.
The Declaration of Conformity can be read online at
www.go-europe.com.
The «Geprüfte Sicherheit» mark (GS tested safety
mark) certifies that the product satisfies the
requirements defined by the German Product
Safety Act (ProdSG).
The GS tested safety mark indicates that when
implemented for its intended use and in the event of
foreseeable misuse the identified product will not
endanger the safety and health of the user. It
concerns a voluntary safety mark which was issued
by an authorized testing institute.
- 11 -
Publicidad
