Quick Test (Battery) - Tecnotest 3167 Manual Operativo

________________________________________________________________________BATTERY TESTER
16. The fourth screen of test results displays the starting system test results, which
includes the cranking voltage (voltage during starting) and condition.
NOTE:
When you reach the last screen, optionally use the Up Arrow key to review the
previous screens.
17. If you have the printer, optionally print the test results.
18. To end the test and return to the main menu, press the MENU key.
19. Select another test or disconnect the clamps from the battery.
20. Press the OFF key to turn the tester off (the tester turns off automatically after a
few minutes of inactivity).
3.4 -

Quick test (Battery)

The quick test is a 1 second test to determine the battery voltage and actual Cold
Cranking Amperes (CCA), Cranking Ampere rating (CA), Ampere Hours (A-HR),
Japanese Industrial Standard (JIS), and German-Deutche Industry Norm (DIS) if
applicable.
To do the quick test, follow these steps:
1. Do the steps in "Pretest Steps" on chapter 3.1. This displays the main menu on
the tester.
NOTE:
The word GO indicates the selected item.
2. Use the Up and Down Arrow keys to select QUICK TEST and then press the
GO key. This displays the Choose Battery Type screen.
OPERATING INSTRUCTIONS
CRANKING V =10.89
GOOD
PRINT RESULTS 'GO'
MORE RESULTS
OUT OF VEHICLE
IN VEHICLE
QUICK TEST
MULTIMETER
Choose Battery Type
Conventional Batt.
AGM Battery
GO

51