Location And Assembly - Ecler verso 8 Manual De Instrucciones

8. LOCATION AND ASSEMBLY

The following general rules should be observed:
•
Stand or hang the cabinets on solid, firm surfaces.
•
There must be no obstacles between the cabinets and the audience. High frequencies,
unlike low ones, are extremely directive and any obstacle will cause an attenuation in its
response.
•
For large audience areas, the higher the cabinets are placed, the better the propagation of
the sound over the distance. To achieve this, use standardised tripods (with a stem 35 mm in
diameter, such as the ECLER TRIPO1 model), which should be inserted into the casing
specially provided for that purpose located on the inner side of the box.
•
The VERSO 8, 10 and 12 models are also prepared for operation on the ground, when laid
flat (e.g., for use as a stage monitor), without the need to use any optional accessories.
•
For wall mounting, an optional accessory is required: reference SR12 for VERSO model
12 / reference SR8 for VERSO models 10 and 8. In this case, an additional safety cable must
also be used (see details in section 10).
•
If the cabinets are hung, 6 anchoring points will be required: 3 nuts embedded on the top
side and 3 more on the lower side which under the rubber feet (see diagram in section 10).
•
Do not hang the equipment by its carry handles.
6