Hamilton Beach Commercial HBH750 Serie Manual De Operación página 5

Control Panel
SELECT Button
Hold to program
unit or review
diagnostic
information.
Cycle Buttons 1–5
Use preprogrammed cycles
or create custom programs.
NOTE: Press any key to stop operation.
Blender Operation – Quick Start Guide
1. Read Important Safety Instructions and Warning
Symbol Explanations before use.
2. Place the blender on a dry, level surface.
3. Make sure the power switch is OFF (O). Plug the
blender into a grounded 3-prong electrical outlet.
4. Place the container on the base with ingredients
and container lid in place.
Sanitizing
Sanitize using 1 tablespoon (15 ml) of household
bleach per 1 gallon (3.8 liter) of clean, cool water
(60°F/16°C), mixed according to the instructions
on the bleach.
1. Fill container with sanitizing solution, replace lid
and filler cap and run on LOW speed for 2 minutes.
Empty container.
2. Wipe exterior with soft cloth dampened with
sanitizing solution.
Display
See the following pages for
status messages.
SELECT
1 2
20 20
Scroll Buttons
Press the
through options in the display or to
adjust settings.
3 4 5
5. Turn the blender on by pressing the Power Switch
marked Reset [ON (I)] / OFF (O). The red LED
switch indicates that power is ON (I).
6. Select the desired function.
7. Use any button to stop operation.
21
3. Immerse lid and filler cap in sanitizing solution
for 2 minutes.
4. Place empty container on base and run on HIGH
speed for 2 seconds to remove any moisture from
the cutter assembly.
5. When ready to use, rinse with clean water.
or button to scroll
P
PULSE Button
Press and hold to
run the blender at
HIGH for short bursts.
22
5