Publicidad
Idiomas disponibles
Idiomas disponibles
FOREWORD
We thank you for choosing our product. It is designed for you according to the highest quality
standards. Please read the operation manual carefully before using and operating the unit. Heed
all warnings. If the device is passed on to another person, this manual must be handed over to the
user along with it. Please keep this manual handy for future reference.
INTENDED USE
This product is to be used as a car parking sensor. It is easy to install. This system detects the
distance between the car body and obstacles in the back with ultrasonic sensors installed on its
license plate holder. With the change of alarm sound, the product can detect and alert obstacles
correctly. It is best choice for the safety of your car.
SAFETY INSTRUCTIONS
Read this user manual carefully before using the product. If you do not observe the instructions
on proper handling in this manual, we shall not be held liable for any resulting personal injury or
damage to property.
1.
Please install this product within the voltage range specified. Failure to do so can cause electric
shock or product malfunction.
2. Electric shocks or product malfunctions may occur if this product is installed incorrectly.
3. If smoke or a burning smell is detected, disconnect the system immediately.
4. When you install the system, the car should be in powered off state.
5. Pay attention to the difference on the size of the hole saw for the sensors. The sensor should
not be installed too tightly or too loose.
6. Do not locate the control unit near to other interference such as exhaust pipe or other wires.
7. Where the power cable may touch a metal case, cover the cable with a friction tape. A short
circuit or disconnected wire may cause a fire.
8. Feed as much cable as possible into the vehicle and clamp it securely. This reduces the
possibility of the cable being hooked or snagged.
9. Keep all cables away from hot or moving parts and electrical noisy components.
10. The performance may be affected in the following situations: heavy rain; the gravel road,
bumpy road, sloping road and bush; metal bumper; very hot, cold or moist weather; the sensors
are covered by snow, ice mud, etc. Other ultrasonic or electric wave, e.g. the DC/AC switch or
24V/12V switch may affect the performance of the system.
11. Test the system to make sure it works well before using.
12. This system is a reversing aid and the manufacturer takes no responsibility for any accidents
caused after the kit is installed.
USER MANUAL
EN
17
Publicidad
