Publicidad
Idiomas disponibles
Idiomas disponibles
Tank gauge
Draining
The water can be drained:
3. Via the tank (E). The water condensate is
collected in the tank and when the tank is full,
the float inside puts the appliance in stand-by
and the
indicator light turns on. Remove the
tank without spilling any water, empty it and dry
it. Check that the chain is fully closed, and
replace the tank correctly in its seat (after a few
seconds the tank full LED turns off).
4. Continuous
The continuous drainage spout is located on the
back of the appliance. Connect the rubber tube with
an internal diameter of 10 mm and maximum length
of 30 cm (comes supplied with some models). Make
sure the connection does not leak. Check that the
drain is at a lower height than the spout and that the
whole tube is sloping evenly and that it is lower than
the spout.
Do not remove the water tank from its place.
If continuous drainage is not in use, remove the
drainage tube.
Indicates that the tank is full.
If the tank is not inserted correctly, the indicator light turns on
but no "beep" is heard and the appliance will only operate for a
few minutes before the dehumidifier turns off.
Publicidad
