D-Link DWR-712 Guía De Instalación Rápida página 4

Idiomas disponibles

TROUBLESHOOTING

SetuP AND CONFIGuRAtION PROBLeMS

1. HOW DO I CONFIGURE MY DWR-712 ROUTER OR CHECK MY WIRELESS NETWORK

NAME (SSID) AND WIRELESS ENCRYPTION KEY?

- connect your pc to the router using an ethernet cable.

- open a web browser and enter the router's Ip address: http://192.168.0.1

- log into the router using the default username admin, the default password is (leave the field blank).

- once logged in, you can use the wizard to configure the router, or make changes manually.

Note: If you have changed the password and cannot remember it, you will need to reset the

router to factory defaults.

2. HOW DO I RESET MY DWR-712 ROUTER TO FACTORY DEFAULT SETTINGS?

- If you cannot remember your router administrator password, you may use an implement such as

a straightened paperclip to press and hold the reset button on the front of the router for about

10 seconds.

Note: Resetting the router to factory default will erase the current configuration. to reconfigure

your router, log in as outlined in question 1, then run the setup Wizard.

3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY

WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?

- every pc that needs to connect to the router wirelessly, you will need to ensure you use the

correct Wireless network name (ssId) and encryption key.

- use the web based user interface (as described in question 1 above) to check or choose your

wireless settings.

- make sure you write down these settings so that you can enter them into each wirelessly

connected pc. You will find a dedicated area on the back of this document, this important

information for future use.

4. WHY AM I UNABLE TO ESTABLISH AN INTERNET CONNECTION?

- If connecting using a 3.75G mobile connection, make sure that you are within range of the mobile

service provider, and that the service has been correctly configured.

- If connecting using the Wan via adsl/cable service, make sure the modem has been enabled/

connected and is operational, and that the service is correctly configured.

DWR-712