Teac A-R650MK II Manual Del Usuario página 13

Tone Control
Turn the BASS knob to adjust the level of low frequency
information.
Turn the TREBLE knob to adjust the level of high frequency
information.
Source Direct
Press this button to turn on or off the source direct function.
When the source direct function is set to on, the button lights
and you can listen to the sound without tone effects.
Automatic power saving function
This unit has an automatic power saving function.
When the unit is shipped new, the automatic power saving function is
on, so it will automatically enter standby mode if none of the follow-
ing controls on the main unit (or any remote control buttons) are used
for the set amount of time (default setting: 8 hours).
o INPUT SELECTOR
o TAPE 2 MONITOR button
o MUTE button
o SOURCE DIRECT button
Checking the setting
When the unit is on, press the TAPE 2 MONITOR button for at least
5 seconds. This will cause an indicator to blink according to the setting.
This table shows the relationship between the setting and the blink-
ing indicator.
Indicator
AUX1
AUX2
TAPE1/CD-R
TUNER
PHONO
CD
TAPE 2 MONITOR
To end setting confirmation mode, press the TAPE 2 MONITOR button
for at least 3 seconds.
CAUTION
No sound will be output from speakers or headphones while this set-
ting is being checked.
Changing the setting
1
When the power is off, press the POWER button while
pressing and holding the TAPE 2 MONITOR button to
turn the unit on.
The CD indicator will blink.
o The setting is always set to 8 hours when the unit is turned on.
2
Press the TAPE 2 MONITOR button to change the
setting.
The setting and corresponding indicator change in the following
order each time you press the TAPE 2 MONITOR button.
w8 hours (CD) wautomatic power saving off (TAPE 2 MONITOR)
w1 hour (AUX 1) w2 hours (AUX 2) w3 hours (TAPE 1/CD-R)
w4 hours (TUNER) w6 hours (PHONO)w
3
Press the STANDBY/ON button to complete the
setting.
CAUTION
If the POWER switch is turned off or the power supply to the unit
is otherwise interrupted, the setting will be restored to its default
value of eight hours.
Setting time
1 hour
2 hours
3 hours
4 hours
6 hours
8 hours
Automatic power saving off
13