Chauvet Professional VIDCURVEKIT1 Guía De Referencia Rápida página 3

Selecting the Angle
The angle of curvature provided by the VID-CURVEKIT can be set to 5° or 10°. To select which angle to use, slide the
male speego connections up or down to the desired slots on the male brackets.
Angle Selection Diagram
Top Male Bracket
5°
Installing on F-Series Panels
To install the VID-CURVEKIT on an F-Series video panel, screw the M12 33 mm screws through the lock washers,
through the brackets, and into the M12 mounting points on the panel as indicated below.
M12 33 mm Screw
Lock Washer
The VID-CURVEKIT is only intended for use when the panels are positioned vertically with the curving
hardware secured along the vertical edges of the panels. Always follow standard practice and ensure
that each column of panels is secured from overhead using the rig bars. DO NOT use the VID-
CURVEKIT when hanging the panels horizontally (with the curving hardware secured along the top
and/or bottom horizontal edges of the panels). The VID-CURVEKIT is not intended to be used in this
application.
VID-CURVEKIT QRG Rev. 2
QUICK REFERENCE GUIDE
10°
Top Male Bracket
F-Series Panel
Bottom Male Bracket
5°
EN
10°
2