Publicidad
Idiomas disponibles
Idiomas disponibles
5. Insert the micro USB cable into the micro USB port on the
rear of the table fan. Then plug the USB mains adapter (USB
mains adapter not included in delivery) into a suitable wall
socket. Arrange the micro USB cable such that it does not
pose a trip hazard.
Alternatively, you can also operate the table fan using your
computer. To do this, connect the table fan to the computer
via the USB port. Make sure that the output values of the USB
socket comply with information on the rating plate.
6. Press the ON/OFF button to switch on the table fan.
A blue indicator light below "ON/OFF" will light up.
7. The table fan has three speeds.
Use the FAN button to select your desired speed.
low speed
1 =
medium speed
2 =
high speed
3 =
8. Press the ON/OFF button to switch the table fan off again.
The blue indicator light below "ON/OFF" will disappear.
If you do not intend to use the table fan for an extended period of time, unplug the mains
adapter from the wall socket/unplug the micro USB cable from the computer.
9. After each use, remove the residual water from the water basin, so that no water can
escape in the event of accidental impacts. To remove the residual water from the water
basin, proceed as follows:
• Make sure that the table fan is unplugged.
• Pull the PET bottle and bottle adapter straight up and off.
• Press the front and rear housing release latches.
• Carefully lift the housing straight up and off
• Empty any residual water from the water basin into the sink.
• Allow all parts of the table fan to dry completely.
• Change the drinking water in the PET bottle daily.
26
Publicidad
