Publicidad
Idiomas disponibles
Idiomas disponibles
9
12
11*
10*
14*
16*
15*
17
1
2
3
7
5
6
* Depending on the model
* Μόνο ορισµένα µοντέλα.
* Len niektoré modely
* Nur bestimmte Modelle
* Только для отдельных моделей
* Samo nekateri modeli
* Alleen bepaalde modellen
* В залежності від моделі
* Samo nekateri modeli
* Suivant les modèles
* Samo određeni modeli
* Ainult teatud mudelid
* Solo per alcuni modelli
* Pouze u některých modelů
* Tikai noteiktiem modeļiem
* Sólo algunos modelos
* Само за някои модели
* Tinka tik kai kuriems modeliams
* Tylko niektóre modele
* Apenas para alguns modelos
* Csak egyes típusok esetén
* Disponibil numai pentru unele modele
* Yalnýzca belirli modellerde
English
•
Unwind a sufficient length of cable and insert the plug
DESCRIPTION OF PARTS
12. Dual purpose floor
into the power socket. A YELLOW mark on the power
nozzle
cable shows the ideal cable length. Do not extend the
1.
Suction inlet
13. Combination crevice
cable beyond the RED mark.
2.
Dust container indicator
nozzle / brush *
•
Press the ON/OFF button to switch the appliance on.
3.
Variable power control
14. Upholstery nozzle *
On initial start up full power is reached after
4.
Cable rewind button
15. Hard floor nozzle *
approximately 1-2 seconds.
5.
On/off switch
16. Turbo nozzle *
•
To rewind the power cable, press the rewind button with
6.
Wheel
17. Cartridge filter
foot, and guide the cable with hand to ensure that it
7.
Dust container
18. Protector mesh
does not whip causing damage.
8.
Carrying handle
13*
19. Parking position
•
By moving the variable power control, the suction
9.
Hose
power can be adjusted.
10. Telescopic tube *
*
Depending on the model
11. Plastic tubes *
MAINTENANCE
REMOVING THE CONTENTS OF THE DUST CONTAINER
Never operate the cleaner without the dust container
IMPORTANT SAFEGUARDS
installed.
•
Read this instruction booklet carefully.
The dust container must be emptied if the window of the
18
•
Before using the appliance, check that the mains power
dust container indicator changes into red when the
voltage corresponds to the voltage shown on the rating
cleaner is operating at maximum power and the nozzle
plate.
is raised from the floor.
•
Do not switch the appliance on if it appears to be faulty
32 If the dustbin indicator is activated than firstly check the
in any way or it has a damaged cord or plug. Do not try
air inlet channel of the appliance. If it is clogged by big
to repair the appliance by yourself. For repairs and
pieces of paper, dust, hair or other materials then clean
accessories we are at your service from Monday to
it. If after cleaning the dustbin indicator stayes
8
Friday from 8am to 6pm
activated check the HEPA.
•
Always remove the plug from the power socket when
21 Remove the dust container from the cleaner.
4
the appliance is not in use and before carrying out any
22 Remove the filter set from the dust container by taking it
cleaning or maintenance operations.
in the way indicated in the icon.
•
Never leave the appliance unattended when it is
23 Remove the contents of the dust container.
switched on. Keep the appliance out of reach of
22 Put the filter set back into the dust container.
children.
21 Put the dust container back into the cleaner.
This appliance is for domestic use only. Use as
•
described in this instruction booklet.
Menalux branded filters are strongly recommended
•
Do not pull the appliance by the cord. Do not unplug by
by Zanussi. Those high quality filters will ensure a
pulling on the cord. Do not use the cleaner with a
long lifetime of your Zanussi vacuum cleaner. For
damaged cable. If the cable damaged, it should be
more information about Menalux products, please
replaced at a service center. This is not covered by the
visit our website: www.menalux.com.
warranty.
•
Do not use appliance on wet surfaces or to vacuum
CLEANING THE FILTERS
liquids, mud, ash and burning cigarette butts. Do not
•
Filters should be replaced at least twice a year or when
vacuum up any highly flammable or explosive
they become visibly soiled.
substances or gases.
Disconnect from electrical outlet before changing the
•
These materials can cause serious damage to the
filters.
motor - a damage which is not covered by the
warranty.
Cleaning the cartridge filter
•
Do not unplug the vacuum cleaner with wet hands.
Always operate the cleaner with the cartridge filter
Do not operate the vacuum cleaner too close to heaters
•
installed.
and radiators, stoves etc.
21 Remove the dust container from the cleaner.
Before you start using the vacuum cleaner, please
•
22 Remove the filter set from the dust container by taking it
remove large or sharp objects from the floor to prevent
as indicated in the icon.
damage to the dust container and hose.
24 Remove the cartridge filter by turning it counter -
clockwise (A) and pull it out (B) as indicated in the icon.
INSTRUCTIONS FOR USE
25 Remove the protector mesh from the cartridge filter.
•
Before placing into operation make certain that the
26,27 Shake the dirt from the filter and the mesh into a bin,
filters are in the proper position.
if necessary the filter and mesh can be rinsed, with cold
20 To connect the hose into the suction inlet push it until it
water, under a tap.
clicks.
20 To disconnect the hose from the suction inlet push the
button at the end of the hose.
1
19
20
B
22
23
A
25
26
29
30
28
32
31
21
24
27
Publicidad
