Sinbo SAH 6101 Manual De Instrucciones página 11

OPERATING THE UNIT
• It is recommended that the device is operated under temperatures 5-40 ˚C and in an
environment with 80% relative humidty.
• Leave the device to rest in room temperature for half an hour prior to first usage.
• Separate the water reservoir located on the top part, from the main bottom unit.
• Turn the water reservoir upside down and open the round cover on the bottom side.
• Fill the reservoir with clean water at room temperature, close the cover tightly and
place it on the device body carefully.
• Insert the power plug into the wall outlet.
• Turn the on/off switch to I position and operate the device.
• Select the desired level using the steam density setting.
WARNING: Do not operate the device if the water reservoir is empty.
IMPORTANT: Note that humidity rate can vary according to the environment.
NOTE: The device can be operated for approximately 30 hours at the highest steam level
with 6 lt. water reservoir.
CLEANING AND CARE
If the water is hard, in other words, if it contains to much calcium and magnesium; these
substances cause white calcification problem. Calcification may occur on the surface of
water reservoir and converters in the bottom unit. Calcification on the surface of the
converter may impair operation.
Cleaning the Converter
1. Drip 5-10 drops of vinegar on the surface of the converter and wait for 2-5 minutes.
2. Clean off the stains using a brush without scratching the surface.
3. Wipe the converter using clean water.
Cleaning the Reservoir
1. Clean the water reservoir using vinegar if there is calcification.
2. If calcification has covered the cover of water reservoir, drip vinegar on it and clean
it using a brush without scratching.
3. Clean the water reservoir once in 3 days.
4. Do not let water to remain in the reservoir for more than 2 days.
RECOMMENDATIONS
1. Use boiled and cooled or distilled water to prevent calcification.
2. Clean the converter and water reservoir every week.
3. Replace the water inside the water reservoir to keep it clean.
4. Ensure that all components of the device are dry when not in use.
- 9 -