Descargar Imprimir esta página

EuroLite TF-5 DMX-Flower-Effect Manual Del Usuario página 24

Publicidad

Idiomas disponibles

Idiomas disponibles

Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
DMX-512 connection / connection between fixtures
Projector 1
Starting address 1
Type: TF-5 DMX-Flower-Effect
Power supply: 230 V AC, 50 Hz ~
Power consumption: 300 W
Fuse: F 3.15 A, 250 V
Lamp: EHJ 24 V/250 W G-6.35
T =45° C
T =80° C
a
B
F
0,5 m
Microphone
®
eurolite
XLR occupation:
www.eurolite.de
1: Ground
2: Signal (–)
MADE IN CHINA
3: Signal (+)
www.eurolite.de
120 Ohms
The wires must not come into contact with each other, otherwise
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
DANGER TO LIFE!
Projector 2
Starting address 3
Type: TF-5 DMX-Flower-Effect
Power supply: 230 V AC, 50 Hz ~
Power consumption: 300 W
Fuse: F 3.15 A, 250 V
Lamp: EHJ 24 V/250 W G-6.35
T =45° C
T =80° C
a
B
F
0,5 m
®
eurolite
XLR occupation:
www.eurolite.de
MADE IN CHINA
the fixtures will not work at all, or will not work properly.
International
L
N
Type: TF-5 DMX-Flower-Effect
Power supply: 230 V AC, 50 Hz ~
Power consumption: 300 W
Fuse: F 3.15 A, 250 V
Lamp: EHJ 24 V/250 W G-6.35
Microphone
1: Ground
2: Signal (–)
3: Signal (+)
www.eurolite.de
24/55
Projector 3
Starting address 5
T =45° C
T =80° C
a
B
F
0,5 m
Microphone
®
eurolite
XLR occupation:
www.eurolite.de
1: Ground
2: Signal (–)
MADE IN CHINA
3: Signal (+)
www.eurolite.de
DMX-512 Controller
00025987.DOC, Version 1.3

Publicidad

loading