ErgoAV ERDS1-01G Manual De Instrucciones página 5

Step 2
The Legs [02]&[03] are pre-tilted according to the view, and the grooves on both
sides of the rear end are used to snap into the protruding parts on both sides of the
side plate. Rotate and press the legs downward. After the legs are installed, connect
the power cable as shown.
Before installing the left leg, press
down the power cable first.
HEAVY! You may need assistance for this step.
When pressing down the power cable, you need a assistance to hold the table leg.
02
01
Snap into the protruding parts
on both sides of the side plate.
05
03