NORAUTO NO3197 Manual página 32

Drill for camera
Testing
1. If the monitor/car radio (need to buy separately
or use your existing one) does not show the rear
view, check that polarity of the power is correct;
if the cables are connected correctly, check
whether the voltage is higher than 10.5V. Also
check the plug on the display is well connected.
2. If the image is gradient or reversed, check if the
camera is installed correctly.
3. In case of abnormal display such as strips,
inclined lines, check if the camera and monitor
are compatible.
a. Replace the camera with a new one to see if
the camera and monitor work. If the monitor
works, the original camera can be deemed as
defective and needs to be replaced.
b. If the monitor still does not work, this is
probablly because the monitor and camera
are not compatible with each other. Try to use
another monitor to see if it is compatible with
the camera.
EN
31