Publicidad
Idiomas disponibles
Idiomas disponibles
Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to
prevent unintended starting. Always wear safety glasses during operation
or while performing any adjustments or repairs.
Interval
Each use
1.
2.
3.
4.
5.
6.
Every 25 hours
1.
Every 50 hours
1.
2.
Every 100 hours
1.
2.
Every season/Before storage
1.
2.
3.
After mowing
1.
2.
Once Monthly
1.
2.
Before performing any maintenance or repairs, disengage the PTO, move
the drive control levers fully outward in the neutral position, engage the
parking brake, stop the engine and remove the key to prevent unintended
starting.
Engine Maintenance
Refer to the Kohler Owner's Manual for all engine maintenance procedures and
instructions.
Changing the Engine Oil
If the engine has been recently run, the engine, muffler and surrounding
metal surfaces will be hot and can cause burns to the skin. Exercise caution
to avoid burns.
To complete an oil change, proceed as follows:
1.
Locate the oil drain port on the left side of the engine.
SERVICE AND MAINTENANCE
MAINTENANCE SCHEDULE
WARNING
Item
Mower and exhaust area
Hydraulic Transaxle
Tires and pressure
Deck, mower and drive belts
Blades and bolt tightness
Safety switch operation
Spindle Bearings
Wear Points
Grease fitting
Cooling shrouds and cooling
areas
Fasteners and components
Pivot points
Control handle
Extension spring
Mower and exhaust area
Wear points
Spindle Pulleys
V-Belt
WARNING
WARNING
Follow the maintenance schedule given below. This chart describes service guidelines
only. Use the Service Log column to keep track of completed maintenance tasks. To
schedule service from Sears Parts & Repair, call 1-888-331-4569.
Service
1.
Clean
2.
Check for leaks
3.
Check
4.
Check
5.
Check
6.
Check
1.
Grease
1.
Lubricate
2.
Lubricate
1.
Remove and clean
2.
Check and secure
1.
Lubricate
2.
Lubricate
3.
Lubricate
1.
Clean
2.
Lubricate
1.
Clean
2.
Clean
2.
Pop open the protective cap on the end of the oil drain valve to expose the drain
port. Refer to Figure 21. Remove the oil fill cap/dipstick from the oil fill tube.
Dipstick Oil Fill Cap
Oil Fill Tube
Oil Drain Port
20
Service Log
Oil Drain Hose
Figure 21
Publicidad
