Valex B8FF7EFA Instrucciones De Uso E Instrucciones De Seguridad página 13

sheet, clean, put on the new sheet, close the tensioning device, check
that the sheet is taut and that the holes correspond to the holes on the
backing plate
- Belt type: Turn the machine over, open the tensioning lever, extract the belt,
clean, insert the new belt taking care to respect the rotation direction,
checking the arrow printed on the machine against that on the belt, close
the tensioning lever, check that the belt is taut and, if necessary, adjust
the centring using the knob.
- For all: At the end, carry out a trial run.
PROBLEMS, CAUSES AND SOLUTIONS
PROBLEM
The electrical tool fails Power supply line
to start disconnected
Plug not inserted
Electrical fault
The sander starts but
Worn abrasive support
does not sand the ma-
Unsuitable abrasive
terial or not very well
support
Abrasive support
not taut
Abrasive support
assembled in wrong
direction
Abrasive support
La The sander starts
not taut
but the belt abrasive
support does not turn
Mechanical fault (worn
or broken belt)
IMPORTANT! If the electrical tool still fails to operate correctly after
you have carried out the above operations, or in the event of ano-
malies other than those described above, take it to an authorised
service centre with proof of purchase and ask for original spare
parts. Always provide the information shown on the technical data
label.
CAUSES SOLUTIONS
Check the electric
power supply line
Insert the plug in the
electric power supply
socket and press the
start button
Contact an authorised
service centre.
Replace the abrasive
support
Change the type and grain
of the abrasive support
Reposition the abrasi-
ve support correctly
Respect the rotation
direction and reas-
semble the abrasive
support correctly
Operate the lever to
tension the belt
Contact an authorised
service centre. Note:
Replacement of the
belt is not covered by
the warranty.
STORAGE
Clean the machine and all its accessories thoroughly (see Maintenance
section). Protect the unpainted parts with protective oil (excluding the
driving rollers) and use the original packaging or case (when fitted) to
protect it.
Keep the machine out of reach of children, in a stable and safe position.
The place must be dry, free from dust, temperate and protected from direct
sunlight.
Keep children and unauthorised personnel out of the storage room.
DISPOSAL
PIn order to protect the environment, proceed according to the local laws in
force. Contact the relevant authorities for further information on this.
When the machine is not longer useable or repairable, deliver the machine
and packaging to a recycling centre.
Electric and electronic waste may contain potentially hazardous sub-
stances for the environment and human health. It should therefore not be
disposed of with domestic waste, but by means of differentiated collection
at specific centres or returned to the vendor in the event of purchasing new
equipment of the same type. The illegal disposal of such equipment may
result in prosecution to the full extent of the law.
WARRANTY
The product is protected by law against non-compliance with the
declared characteristics provided it is used only in the manner
described in the instructions, it has not been tampered with in any
way, it has been stored properly, has been repaired by authorized
and, where applicable, have been used only original spare parts.
In the case of industrial or professional use or when using such a
guarantee is valid for 12 months.
To issue a claim under warranty you must present proof of pur-
chase to your dealer or authorized service center.
AMENDMENTS
The text, figures and data correspond to the standards in place on the date
of printing the instructions contained herein. The manufacturer reserves
the right to update the documentation if changes are made to the applian-
ce, without being bound by any obligations.
No part of this publication and the documentation enclosed with the machi-
ne may be reproduced without written permission from the manufacturer.
©
- 13 -