EINHELL TE-AC 270 Manual De Instrucciones Original página 27

then please contact the customer service
workshop.
Do not lose these safety instructions
2. Layout and items supplied
2.1 Layout (Fig. 1-4)
1. Intake air fi lter
2. Pressure tank
3. Wheel
4. Foot
5. Quick-lock coupling (regulated compressed
air)
6. Pressure gauge (for reading the set pressure)
7. Pressure regulator
8. On/Off switch
9. Transport handle
10. Safety valve
11. Drainage screw for condensation water
12. Pressure gauge (for reading the vessel pres-
sure)
13. Quick-lock coupling (unregulated com-
pressed air)
14. Oil sealing plug
15. Oil drainage screw
16. Overload switch
17. Oil level window
18. Wheel cap
19. Screw (internal hexagon) for fi tting the handle
20. Wrench (hexagon)
21. Screw
22. Washer
23. Nut
24. Axle screw
25. Spring washer
26. Nut
27. Oil fi ller opening
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
Anl_TE_AC_270_50_10_SPK8.indb 27 Anl_TE_AC_270_50_10_SPK8.indb 27
GB
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Intake air filter
•
Wheel (2x)
•
Foot
•
Transport handle
•
Oil sealing plug
•
Wheel cap (2x)
•
Screw (internal hexagon) for fitting the handle
(4x)
•
Wrench (hexagon)
•
Screw (2x)
•
Washer (8x)
•
Nut for fitting the foot (2x)
•
Axle screw (2x)
•
Spring washer (2x)
•
Nut for fitting the axle (2x)
•
Original operating instructions
3. Proper use
The compressor is designed for generating
compressed air for tools operated by compressed
air.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
- 27 -
15.12.15 09:02 15.12.15 09:02