DJI RELAY Guía De Usuario página 3

Disclaimer
Carefully read this entire document and all safe and lawful practices provided before use.
Introduction
DJI TM Relay works at 2.4 GHz and 5.8 GHz, which can transmit signals with a supported DJI remote controller and
[1]
aircraft, respectively. The stable signal transmission can avoid signal being blocked in complex environments.
The total working time of the relay is up to 4 hours and can be extended using a mobile power supply. With the
mount, the relay can be set up using extension rods of different heights.
Overview
1
2
[1] Refer to Specifications to check supported products.
[2] When using the provided USB-C cable to connect the mobile power supply, insert two screws from the packaging into
the screw holes besides the USB-C port to secure the cable.
Getting Started
Charging the Relay
Charge the relay through the USB-C port using the charging cable (included) and a USB charger (not included).
The battery is fully charged when all the battery level LEDs are on, which takes approximately 2 hours and 20
minutes. It is recommended to fully charge the battery before using it for the first time.
• It is recommended to use USB Power Delivery chargers.
2
5
3
6
7
1. Detachable Antennas
Transmit wireless signals.
2. Water Vent
3. Power Button
Press once to check the battery level.
Press, then press and hold to power on/off.
4. Status LEDs
Indicate the linking status between the remote
controller (RC) or aircraft (UAV) with the relay.
5. Battery Level LEDs
Indicate the battery level.
6. 5/8" Screw Hole
For installing the mount.
7. USB-C Port
For charging, connecting a mobile power supply
or firmware updates.
[2]