DJI RELAY Guía De Usuario página 4

Installation
Mount the detachable antennas onto the relay.
Linking
Follow the steps below to link before using it for the first time.
1. Power on the remote controller and aircraft, and make sure the two devices are linked.
2. Power on the relay. After the status LEDs turn solid red, press and hold relay power button to prepare for
linking.
3. Open the DJI AGRAS TM
successfully, the status LED (RC) of the relay will glow solid green.
4. After connecting with the remote controller, the relay will link with the aircraft automatically. The linking is
successful when the status LED (UAV) becomes solid green.
• Make sure the remote controller and aircraft are within 0.5 m of the relay during linking.
• If linking fails, try again after checking the operation and the firmware version. Contact DJI Support if
the issue persists.
Activation
Activation is required before using it for the first time. Follow the instructions on DJI Agras to activate the relay
after linking.
Using the Relay
During usage, it is recommended to set up the relay in high places (such as roofs and high hills) to solve the
problem of signal blockage in orchards or fields with tall crops. Follow the instructions below to set up.
1. Install the mount to the relay via the 5/8" screw
hole.
app and tap Device Management, then tap Relay > Link to start linking. After linking
2. Insert the extension rod into the mount via the
screw hole, or attach the extension rod by rope.
Users can select extension rods of different heights
(not included) according to their requirements.
3