Descargar Imprimir esta página

Hitachi P42H401A Guia De Funcionamiento página 39

Publicidad

Idiomas disponibles

Idiomas disponibles

Channel Manager
Channel Manager
Select CHANNEL MANAGER to set your Antenna
options, run Auto Channel Scan, Check Signal Meter
and Set Channel List.
1. Press CURSOR PAD
2. Press the SELECT button or CURSOR PAD
select.
Signal Meter
Select SIGNAL METER when using an indoor or outdoor
antenna. This feature will show the signal strength and
peak values of the Antenna signal to help you adjust your
antenna to optimize signal reception.
Use the CURSOR PADS and the SELECT button to
highlight and select CLOSE to exit.
NOTE: The Signal Meter will not be available (grayed
out) when watching analog channels.
Auto Channel Scan
This feature will automatically store active Analog and
Digital channels in Auto Channel Scan memory.
1. Use the CURSOR buttons
CABLE (1) or CABLE(2) source.
2. Press the CURSOR buttons
START or RESET option.
3. Press the SELECT button to select.
NOTE: 1. If certain channels are poor or not possible
in cable(1) mode, set cable source to cable(2)
by using the CURSOR buttons
,
to highlight functions.
to
or
to highlight AIR,
or
to highlight the
or
.
Video
Audio
Channel Manager
Locks
Timers
Setup
Move
Select
SEL
Channel Manager
Signal Meter
OR
Auto Channel Scan
Channel List
Move
Select
SEL
Channel Manager
Signal Meter
OR
Auto Channel Scan
Channel List
Move
Select
SEL
Channel Manager
Signal Meter
Channel
3 - 1
Strength
91
Peak
91
SNR
10
Close
Move
Return
SEL
Channel Manager
Signal Meter
Auto Channel Scan
Channel List
Move
Select
SEL
Channel Manager
Auto Channel Scan
OR
Source
Air
Auto Channel Scan
Start
Move
Return
SEL
Reset
39

Publicidad

loading