Publicidad
Step 4
Carefully turn your unit over onto its front edges. Unfold the BACK (F) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (F). Push on opposite corners of your unit if needed
å
to make it "square".
Fasten the BACK (F) to your unit using the NAILS (P).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (I).
å
Carefully stand your unit upright.
å
Push twelve RUBBER SLEEVES (L) over twelve METAL PINS (M). Insert the METAL PINS into the hole locations of your
å
choice in the ENDS (A and B). Set the ADJUSTABLE SHELVES (E) onto the METAL PINS.
Insert three HOLE PLUGS (R) into the large holes in the TOP MOLDING (H).
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
å
And to celebrate, why not share your success story?
These holes must line
up over the SHELF (I).
NAIL
(45 used for the BACK)
Page 8
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
F
P
(3 used)
R
M
(12 used)
101785
No load
E
35 lbs.
E
35 lbs.
B
I
40 lbs.
A
E
35 lbs.
D
50 lbs.
L
www.sauder.com/services
Publicidad
