Descargar Imprimir esta página

CORBERO CCH610W/V1 Manual De Instrucciones página 65

Publicidad

Idiomas disponibles

Idiomas disponibles

The Wire Grid
The wire grid is best used for grilling or for
processing food in oven-friendly containers.
WARNING
Place the grid to any corresponding
rack in the oven cavity correctly and push it
to the end.
Removal of the Wire Shelf
To remove the wire rack, pull the wire rack
as shown in the figure. After releasing it
from the clips (a), lift it up.
a
The EasyFix Wire Rack
Clean the accessories thoroughly with
warm water, detergent and a soft clean
cloth on first use.
5
4
3
2
1
Insert the accessory to the correct
position inside the oven.
Allow at least a 1 cm space between the
fan cover and accessories.
Take care removing cookware and/or
accessories out of the oven. Hot meals
or accessories can cause burns.
The accessories may deform with heat.
Once they have cooled down, they will
recover their original appearance and
performance.
Trays and wire grids can be positioned
on any level from 1 to 5.
Telescopic rails can be positioned on
levels T1, T2, 3, 4, 5.
Level 3 is recommended for single level
cooking.
Level T2 is recommended for single
level cooking with the telescopic rails.
The turnspit wire grid must be
positioned on Level 3.
Level T2 is used for the turnspit wire
grid positioning with telescopic rails.
****Accessories may vary depending on the
model purchased.
T2
T1

Publicidad

loading