Publicidad
Idiomas disponibles
Idiomas disponibles
FILLING FLUID TANK
Step 1: Unscrew the cap of the fluid tank and to fill with original Beamz smoke fluid only. This fluid is environmentally friendly,
biodegradable and leaves no residue when used correctly.
Step 2: Replace the cap and close securely, ensuring the pipe is fed down to the bottom of the bottle.
Step 3: Open the ice reservoir cover by unscrewing fixation screw. Fill the reservoir with regular ice cubes and close the cover.
Step 4: Connect the mains plug.
OPERATION
Connect the power lead into the ice fogger machine and earthed mains outlet. Then you can switch the power
on by ON/OFF switch.
After a certain warm-up time, the ice fogger machine is ready to operate. Then the stand-by LED of the remote
control lights up. By operating the smoke switch on the remote control the low smoke emission starts. It may
happen that the stand-by lamp turns off and the smoke emission stops. In this case the device is heating up
again and will be ready to operate in approx. 1 min.
Switch off when ice fogger machine not used and unplug from mains if not use for long periods.
Attention: Drain the water in regular intervals (approximately every 30 minutes).
CLEANING
The ice fogger machine must be cleaned to avoid deposits in the machine, pump and heater.
Procedure:
Remove smoke fluid from the tank, fill "Beamz smoke machine cleaner fluid" (item no. 160.670) into empty tank.
1.
2.
Switch the power on and wait until smoke machine is warmed up.
3.
Press on the button of remote control and pump the liquid through the machine.
4.
Perform the above operation until the tank is empty.
5.
Fill the tank with Beamz smoke fluid.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
ACCESSORIES
High quality smoke fluid on water basis, specially designed for Beamz smoke machines guarantees a trouble-free use.
5 liter packaging, ref. no. 160.582
1 liter packaging, ref. no. 160.643
Before filling disconnect from mains!
Do not allow the pump to run dry!
Run clean procedure in a well-ventilated area!
5
Publicidad
