Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. Place fertilizer or seed in the hopper.
5. When starting the machine, the bottom of the blades should be 70cm from the ground for an even distribution, and the tractor RPM should be
at 540.
6. Select the working speed and adjust the hatch openings as specified in the table according to the
amount of product you wish to spread per hectare. (The products whose spreading information is not presented in the tables rely on your
knowledge and experience.)
7. When you begin spreading, always move the tractor at an even speed to ensure an even distribution.
8. Remember that when you go faster, less product is spread per hectare, and vice versa.
9. Engage the PTO at a low rpm and gradually increase the tractor engine rpm to 540.
START-UP (641001)
1. Fertilizer must pass through the sieve to ensure that the fertilizer will flow through the barrel and tubes.
2. Open the fertilizer output using the control wire.
3. Open the boom and adjust the "Y" outputs appropriately, adjusting the dispersal pattern according to the furrow type.
4. Accelerate the tractor engine to 540 RPM on the PTO.
5. Set the tractor speed, and the fertilizer spreader will begin depositing fertilizer at ground level.
UREA
LEVER
POSITION
1
2
3
4
5
B A R L E Y
LEVER
POSITION
4
1
113
2
383
3
4
658
865
5
Ki l ograms/ Hecta r e
Km/h
4
6
8
10
182
122
91
73
555
370
277
222
931
621
465
372 310
1211
807
605
484 404 338
Ki l ograms/ Hecta r e
Km/h
6
8
10
12
75
56
45
38
25
191
153 128
107
439
452
263 219
184 162
577
594
346 288
242 213
12
14
16
Each model has its own spreading table,
61
51
45
185 155 137
260 229
299
W H E A T
LEVER
POSITION
14
16
1
32
28
2
94
3
4
5
6
NOTE:
which is affixed to the hopper.
Ki l ograms/ Hecta r e
Km/h
4
6
8
10
181
121
90
72
372
279
223 186
558
641
480
384 321
962
828
620
496 414
1241
12
14
16
60
51
45
156 138
269 237
347 306
Publicidad
Tabla de contenido
