Publicidad
Idiomas disponibles
Idiomas disponibles
LOCATION
Do not lcoate the range where it may be subject to strong drafts. Any openings in the fl oor or wall behind the range should
be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are
not obstructed by carpeting or woodwork.
Your range, like many other household items, is heavy and can settle into soft fl oor coverings such as cushioned vinyl or
carpeting. Use care when moving the range on this type of fl ooring. It is recommended that the following simple and inex-
pensive instructions be followed to protect your fl oor.
The range should be installed on a sheet of plywood (or similiar material). When the fl oor covering ends at the front of the
range, the area that the range will rest on should be built up with plywood to the same level or higher than the fl oor cover-
ing.
This will alow the range to be moved for cleaning or servicing. Also,make sure your fl oor covering will withstand 180° F.
(See the Installation Safety Instructions section.)
Make sure the cabinets and wall coverings around your range can withstand the heat generated (up to 200° F) by the
range. (See the Installation Safety Instructions section).
IMPORTANT!
Remove all tape and packaging. Make sure the burners are properly seated and level.
Take the accessory pack out of the oven and/or drawer.
Check to be sure that no range parts have come loose during shipping.
INSTALL THE ANTI-TIP BRACKET
STEP 1 LOCATE THE BRACKET
IMPORTANT:
A
Place the bracket on the fl oor with the back edge against
the rear wall. If the range does not reach the rear wall,
align the back edge of the bracket with the rear panel of
the range in its fi nal location.
IMPORTANT:
If the bracket does not touch the rear wall, you MUST
screw the bracket to the FLOOR as described in Step 2.
B
Position the side of the bracket against the right cabinet. If
there is no adjacent cabinet, align the edge of the bracket
with the right side panel of the range in its fi nal location. If
the countertop overhangs the cabinet, offset the bracket
from the cabinet by the amount of the overhang.
C
Mark the location for the pair of holes to be used (see illustration above).
NOTE: For FLOOR installation use Loc. A. For REAR WALL installation use Loc. B.
INSTALLATION INSTRUCTIONS
Determine the fi nal location of the range before attempting to install the
bracket.
Rear wall
Rear Wall
Loc. A
Loc. A
Two screws must enter
Two screws must enter floor
fl oor or wall at Loc. A or B.
or wall at Loc. A or B.
23
Loc. B
Loc. B
Adjacent cabinet
Adjacent cabinet or
or fi nal location of
final location of right
right range side
range side panel
panel
Publicidad
