Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARE THE OPENING
The Advantium Built-In Oven can be installed
in combination with other Built-In appliances.
Always follow each product's Installation
Instructions to complete the installation.
Single Advantium Built-In Oven
Installation:
Order a 27" or 30" wide single oven cabinet
or cut the opening in a wall to the dimensions
shown.
27" or 30"
17-1/2"
36-3/4"
Min.
• Allow the following clearances around the
cutout on the front surface of the cabinet:
to minimum clearances required for installation
and do not reflect actual product dimensions.)
• Oven overlaps will conceal cut edges on all
sides of the opening.
When installed over a single oven or a
warming drawer, allow at least 2" between
the two openings. This separation will provide
clearance for bottom overlap of the Advantium
120 and the other appliance overlaps.
• The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
31-2000355 Rev.2
All manuals and user guides at all-guides.com
Standard Installation Preparation
23-1/2"
25-1/4"
Construct
solid bottom
- Min. 3/8"
plywood
supported
on all four
sides. Must
be able to
support
weight of
oven and
contents.
PREPARE THE OPENING
Installation over a Warming Drawer:
27" or 30"
25-1/4"
17-1/2"
36-3/4"
Min.
clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location does not
obstruct the required interior depth and height. See
Warming Drawer installation instructions for details.
(CONT.)
Construct
23-1/2"
solid bottom
- Min. 3/8"
plywood
supported
on all four sides.
Must be able to
support weight
of oven and
contents.
2 Min.
(3 Recommended)
Per Warming
Drawer
Requirement
NOTE: Additional
5
Publicidad
