Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 7.
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, or when not in use. Removing
battery pack will prevent accidental starting
that could cause serious personal injury.
To install:
Open the battery cover by releasing the latch and opening
the cover.
Align the raised rib on the battery pack with groove in the
battery port and place the battery pack in the tool.
Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.
Close the battery cover and fasten the latch to secure the
cover.
To remove:
Depress the latches on both sides of the battery pack to
release the battery pack and remove it from the tool.
WARNING:
Risk of fire or explosion. Spray area must
be well- ventilated and away from sparks or
flames.
TURNING THE SPRAYER ON/OFF
See Figures 8 - 9.
To start the sprayer, place the ON/OFF switch in the ON
( l ) position.
Turn the control knob clockwise to increase the pressure
and counterclockwise to decrease the pressure.
NOTE: To apply more spray to an area, increase the pres-
sure. To apply less spray, decrease the pressure.
To start the flow of liquid at the spray wand, squeeze the
trigger.
To stop the flow of liquid at the spray wand, release the
trigger.
To stop the sprayer, place the ON/OFF switch in the OFF
( O ) position.
LOCK-ON
See Figure 9.
The lock-on feature is convenient when spraying for an ex-
tended period of time or when covering a large area.
To lock-on, squeeze the trigger and slide the locking tab
backward.
To release the lock-on, squeeze the trigger and slide the
locking tab forward.
NOTE: Make sure the trigger is not locked on before
inserting the battery pack into the sprayer.
ADJUSTING THE CONE SPRAY NOZZLE
See Figure 10.
The cone spray and shower nozzles can be adjusted from
a stream to a spray.
Remove the battery pack from the tool.
Loosen the nozzle for a stream.
Tighten the nozzle for a spray.
USING THE SPRAYER
See Figure 11.
WARNING:
Improper application of cleaning solution can
result in SEVERE INJURY or DEATH. Follow
CDC and EPA guidelines for cleaning. Follow
the chemical manufacturer's safety instructions
and guidelines listed on the SDS sheet.
WARNING:
Risk of fire or explosion. Spray area must
be well- ventilated and away from sparks or
flames.
Install the battery pack into the tool.
Place the ON/OFF switch in the ON ( l ) position.
Set desired pressure.
Slip arm through harness strap and onto shoulder, then
repeat for the other shoulder. Adjust the straps to a com-
fortable position.
Direct the sprayer nozzle directly at the surface areas you
wish to treat.
NOTE: Make sure to stand far enough from the object
being sprayed to prevent the spray from splashing back
onto you.
9 — English
Publicidad
