Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
REVERSING THE DOOR HINGE
1. Remove the top hinge cover.
2. Using Phillips Head Screwdriver, loosen and remove the screws holding the top
hinge in place.
3. Remove top hinge and carefully lift off the door.
4. Remove the screw hole plugs from the opposite side and insert the plugs in the
screw hole openings of the just removed screws.
5. Remove any loose items in the refrigerator and carefully turn refrigerator on its
back and place in a secure area.
6. Loosen the screws holding the lower hinge bracket to the refrigerator and
remove screws and bracket.
7. Remove the screws from the other side and insert in the previously removed
screw holes.
8. Remove door pin by turning counter clockwise and reinsert to the underside of
the bracket and tighten.
9. Align bracket and insert (2) remaining screws into the holes provided.
10. Align hole in the door with the door pin and washer and gently push down until
firm.
11. Align upper hinge bracket with screw holes insert screws and partially secure,
check that door and cabinet are properly aligned and then secure tightly.
12. Replace hinge cap.
Page 10
Publicidad
