Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL SPECIFICATIONS
Rated Voltage/Frequency: 220-240V~ 50/60Hz
Power: 80W
ASSEMBLY OF THE AIR COOLER
1.
Installation of Wheels: place 4 wheels to the holes located at the base of the air cooler. Insert
thewheels tightly to the air cooler's body (Fig.1)
2.
Filling Water: Turn the water tank lock to hori2ontal position, taking out the water tank, put
in the iceboxes and add clean tap water to large section of the to (Fig.-2 and -3). Be sure that
water level in the tank does not exceed the level `'MAX- which is located at the back of the
tank. (Fig.-4)
Your cooler takes water from narrow section of the to and pumps it on the cooling pad. The
water fl owing through the cooling pad spills down to the large section of the tank. This cycle
causes water to absorb dust and dirt in the air. The fi lter at the middle of the tank fi lters and
cleans the water, therefore it should be attached to its place while the device is operating. Push
the water tank to its housing and turn the tank lock to the vertical position
Insert plug to the electrical outlet. The LED indicator showing the room temperature lights with
a beep sound and the air cooler switches to the stand by position. The function of the unit can
be controlled via on board control panel or by remote control.
1.
ON/OFF : Press the ON button on the control panel or press the ONIOFF button on the remote
controlto turn the unit on. The unit Will start at intermediate speed and then drop to slow
speed_ To switch back to the standby position, simply press the OFF button on control panel
or press the ON/OFF button on the remote control.
2.
Speed: Wind speed can be adjusted to 3 levels as low¬ – Med - High by pressing the 'Speed'
EN
9
Publicidad
