Original Prusa XL Manual Del Usuario página 30

PASO 24 Version B: Mounting the LCD: Parts preparation
For the following steps, please prepare:
LCD assembly (1x)
M3x8rT (1x)
PASO 25 Version B: LCD cables
Carefully turn the printer so that the front side is facing you.
From the front of the printer, place the LCD assembly close to the lower front
aluminum extrusion where are the LCD cables.
Using the M3x8rT screw, connect the PE cable to the PE hole on the LCD board.
Connect the LCD cable to the slot on the LCD board.
There is a latch on the LCD cable connector, which must be facing the triangle
symbol on the board. See the detail.
30
3. Instalación de la impresora
Original Prusa XL Cabezal Único (Ensamblada)