MAINTENANCE
1. Lubrication
After using the running belt for a period of time, it is necessary to use special belt oil for
belt sliding. The recommended lubrication time is:
»
Lubricating once every 5 months for usage of less than 3 hours per week. Lubricating once
every 2 months for usage of 4-7 hours per week.
»
Lubricating once every month for usage of more than 7 hours per week.
Note: Do not use too much each time. Approximately 10ml at a time.
2. Check whether lubrication is required
»
Grasp the running belt, and touch the back, of the running belt, as close to the central area
as possible. If there is silicone oil on the belt (or it feels a little wet), it means no
lubrication is needed. If you feel that the running board is dry and there is no silicone oil
on your hand, you need to add oil and lubricate the belt.
»
We have created a practical video on how best to add the oil. You can find the video at the
end of this manual.
3. Deviation adjustment of running belt
»
All treadmills have the running belt deviation adjusted before they leave the factory, but
after a period of use, the running belt deviation may occur, which may be caused by the
following situations:
»
The main part is not placed stably.
»
Uneven force on the user's feet.
»
The deviation caused by human factors will automatically return to normal after several
minutes of no-load operation. For some deviation phenomena that cannot be recovered
automatically, adjust the belt by adjusting the screw by half a turn, and the specific
operation is as follows:
We have created a practical video on how best to center the belt.
You can find the video at the end of this manual.
DR EAVER - TREA DMI LL
»
The user's feet are not in the center of the
running belt when exercising.
8