Eschenbach maxDETAIL Clip Instrucciones De Uso página 9

When you wish to stop using the maxDETAIL Clip, simply flip the
clip up, it is not necessary to remove it.
To allow an optimal line of sight on both large and small eye-
glasses, the lens assembly on the clip can be moved vertically. To
do this, it is necessary to unscrew the lens assembly with a small
Philips screwdriver and rescrew it onto the clip arm at one of 5
possible positions.
The clip should generally lie in the lower line of sight through
the eyeglasses so that you can still orient yourself in the room
by looking through the upper part of the eyeglasses and over
the clip.
If you cannot achieve good results with the Max-Detail Clip, this
may be a result of one of the following situations:
• You may have selected a working distance that is too far
or two short.
• You may be experiencing a vertical offset because you have
attached the maxDETAIL Clip at too steep an angle.
• Your pupil distance may lie outside of the pupil distance
range of the maxDETAIL Clip.
- 9 -