Roborock S8+ Manual Del Usuario página 9

A13-5—Dock Location Beacon
A13-6—Charging Contacts
A13-7—Suction Inlet
A13-8—Electrode Brushes
Auto-Empty Dock (Cover
A14
Removed)
A14-1—Dust Bag Slot
A14-2—Filter
Power Cable Storage
A15
A15-1—Power Cable Storage Slot
A15-2—Cable Outlet
A15-3—Power Port
Note: Power cable can be pulled out at both sides.
Installation
B
Important Information
B1
B1-1— Tidy cables and loose items from the
ground and move any unstable,
fragile, precious, or dangerous items
to prevent personal injury or
property damage due to items
becoming tangled in, struck by, or
knocked over by the robot.
B1-2— When using the robot in a raised
area, always use a secure physical
barrier to prevent accidental falls
that may result in personal injury or
property damage.
Note: When using the robot for the first time, follow it
throughout its whole cleaning route and watch for potential
problems. The robot will be able to clean by itself in future uses.
Position the charging dock
B2
B2-1— Take the screwdriver from its storage
bin at the bottom of the base.
B2-2— Place dock upside down on a soft,
flat surface (carpet/towel/ cloth) and
attach the base by using the six
screws provided.
Note: Hold the dustbin cover securely when upside down to
prevent damage from falling.
Connect the power cable to the
B2-3—
dock, and keep the excess cable
inside the storage slot.
B2-4— Place the dock on a hard and flat
floor (wood/tile/concrete etc.), flat
against a wall. Keep at least 0.3 m
(1 ft) of clearance on either side and
1 m (3 ft) both in front and above.
Make sure the location has good
WiFi for a better experience with the
mobile app, and then plug it in.
B2-4-1—more than 0.3 m (1ft)
B2-4-2—more than 1 m (3ft)
Notes:
• The status indicator light turns off automatically when the
robot is charging.
• The status indicator turns red if an error occurs.
• Do not use without a dustbin cover or dust bag.
08
• Place the dock on a flat floor away from fire, heat, and
water. Avoid narrow spaces or locations where the robot
may be suspended in the air.
• Placing the dock on a soft surface (carpet/mat) may cause
the dock to tilt over and cause problems docking and
departing.
• Keep excess power cable inside the storage slot so that the
robot will not get tangled in the cables, and the dock will not
be dragged away or disconnect from the power supply.
• Keep the dock away from direct sunlight or anything that
may block the dock location beacon; otherwise, the robot
may fail to return to the dock.
• The Auto-Empty Dock recharges and empties. Store the
standard robot dock before use. Failure to do so may cause
issues returning to dock.
• Maintain the dock according to the maintenance
instructions. Do not clean the dock with a wet cloth.
Power on and charge the
B3
robot
Press and hold the button to power on the
robot. When the power light goes on, place
the robot on the dock to charge. Make sure
the charging dock power indicator turns off
and a "charging" voice alert sounds. To
maintain the performance of the high-
performance lithium-ion rechargeable
battery pack, keep the robot charged.
Note: The robot may not turn on when the battery is low. In
this case, place the robot directly onto the dock to charge.
Mopping
B4
Note: To prevent excessive dirt buildup during first-time
use, floors should be vacuumed at least three times before
mopping.
B4-1—Remove the water tank
Press the water tank latch and slide the tank
backwards.