Publicidad
Idiomas disponibles
Idiomas disponibles
10.1
ADJUST THE NAIL DEPTH
Harder materials and longer nails require more force to drive
the nail. Use the depth adjustment wheel to achieve the
desired depth.
1. Remove the battery pack from the machine.
2. Turn the depth adjustment wheel (10) left or right to
change the driving depth.
3. Reinstall the battery pack.
10.2
SINGLE / CONTACT FIRING
MODE
Single firing mode：
Single firing mode provides the most accurate nail placement.
7
1. Push the single / contact firing knob (4) to position T.
2. Depress the safety contact pin (7) against the work
surface.
3. Squeeze the trigger (2) to fire the nail.
4. Release the trigger and safety contact pin after firing.
The safety contact pin must be depressed before the trigger
is squeezed.
Contact firing mode：
10
2
4
NOTE
English
Contact firing mode provides the convenient and fast nail
placement.
1. Push the single / contact firing knob (4) to position TTT.
2. Squeeze and hold the trigger (2) all the time.
3. Depress the safety contact pin (7) against the work
surface.
4. Release the trigger and safety contact pin after firing.
Keep squeezing the trigger all the time during the safety
contact pin is being depressed time by time.
Do not depress the trigger when the tool is not in use to
avoid accidental firing.
10.3
LED LIGHT
8
The LED light (8) illuminates when the trigger is depressed.
It turns off after a delay when the trigger is released.
10.4
LED INDICATOR
The LED indicator will illuminate in specific order to
communicate the current machine status. They are as follows:
Indicator
Red light flash-
9
NOTE
CAUTION
State
The nails are jammed
es
EN
Publicidad
