Using The Vacuum Cleaner - Mx Onda MX-AS2060 ERP II Manual De Instrucciones

USING THE VACUUM CLEANER

Inserting the flexible hose
Take the hose through the F nozzle and insert it into
the hole of the suction inlet, check that the nozzle is
correctly fitted.
To remove the hose, press the button of the nozzle
F and without releasing it pull it outwards.
Telescopic tube insertion
This vacuum cleaner as an accessory incorporates a telescoping extension
tube D. If you need to use it, proceed as follows:
Hold the hose by the handle A and insert the
nozzle of the same in the wider end of the
extension tube D until they are fully engaged.
To adjust the length of the extension tube D,
press the button extension without releasing
remove the inner tube to the desired length.
Stop pressing the button extension and the
inner tube will be retained.
Choice of accessories
You use the right accessory according to the type
of cleaning you. be incurred. According to their
needs or not use extension tube D.
For cleaning window frames, gaps or inaccessible
sites, use the fine nozzle or brush J, and for other
cleaning for example; upholstery can use the
special nozzle K.
Using the floor brush
For cleaning floors stoneware, plate, flooring, etc.
use the floor brush E, with the lever in position
" ".
If floors are carpeted or are carpeted press the
pedal lever, placing it in the "
that the brush is hidden and thus facilitate the
aspiration of the tissue.
To return back to the position Brush press the pedal
lever to the position "
" position, so
".
7
Selector lever