Fulgor Milano FOBQ 803 G X / MBK Instrucciones Para La Instalación Y El Uso página 56

EN
Adapting to different types of gas
2 - Lower the burner and replace the injector.
If the appliance is configured for a different type of gas than
that available, you have to replace the injectors with ones
corresponding to the type of gas to be used (see tables on
the preceding pages). The replacement will be made using
an adequate 7 mm key after having lowered the burners as
in the following images. After replacing the injector, regulate
the air to 1mm for natural gas and to the maximum if LPG.
To adjust the minimum, after lighting the burner, remove the
knob and the gasket below and rotate the screw of the tap
(B - see page 15), which should be totally closed for
LPG and opened about 3/4 turn for natural gas, keeping
in mind that a flame lower than 3 mm may not even be
"perceived" by the thermocouple of the tap. After regulating
the minimums, replace the gaskets and knobs.
1 - Unscrew the fixing screws of the burner.
FRONT
BACK
BACK
FRONT
14