Descargar Imprimir esta página

Sharp SJ-BB04IMXW1-EU Instrucciones página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
CHAPTER -6: TROUBLESHOOTING
• There is enough space at the rear and side walls.
Your fridge freezer is too noisy.
The cooling gas which circulates in the refrigerator circuit may make a slight noise(bubbling sound) even when the
compressor is not running. Do not worry this is quite normal. If these sounds are different check that ;
The appliance is well levelled ,
• Nothing is touching the rear.
If there is water in the lower part of the refrigerator ;
Check that ;
The drain hole for defrost water is not clogged insert a space please (Use defrost drain plug to clean the drain hole)
Recommendations
• In instances of a power cut unplug the appliance. This prevents damage to the compressor. You should delay
plugging in 5 – 10 minutes after you regain power supply. This will avoid damage to components.
• The cooling unit of your refrigerator is hidden in the rear wall. Therefore, water droplets or ice may occur on the
rear surface of your fridge due to the operation of the compressor in specified intervals. This is normal. There
is no need to perform a defrosting operation unless the ice is excessive.
• If you will not use your fridge for a long time (e.g. in summer holidays) unplug it. Clean your fridge according to
Part 4 and leave the door open to prevent humidity and smell.
• The appliance you have purchased is designed for home type use and can be used only at home and for
the stated purposes. It is not suitable for commercial or common use. If the consumer use the appliance in
a way that does not comply with these features, we emphasise that the producer and the dealer shall not be
responsible for any repair and failure within the guarantee period.
• If the problem persists after you have followed all the instructions above, please consult an authorised service
provider.
CHAPTER -7: TIPS FOR SAVING ENERGY
1. Always allow foodstuffs to cool before storing in the appliance.
2. Thaw food in the fridge compartment, this helps save energy.
3. Energy consumption of your appliance is declared without drawers and fully loaded
in freezer compartmant.
4. For saving energy, do not use volume between the load limit and the door, along the
load limit line. Load limit line is also used in energy consumption declaration.
EN -10-

Publicidad

loading