Publicidad
Idiomas disponibles
Idiomas disponibles
Nozzle's water jet shape diagram:
0°nozzle - red
25°nozzle -
Soap nozzle -
black
4. Cleaning
Start with the nozzle 1-2ft away from the surface and
approach with caution until it reaches the desired position
for overly close spray may do harm to surface.
WARNING: Do not connect the machine to water
supplies that are dirty, rusty, muddy or corrosive.
(Including window cleaning liquids, plant foods or
fertilizers etc.)
5. Changing accessories
(1). Release the trigger.
(2). Turn off the power switch (the position" OFF/O").
(3). Disassemble the original adjustable Nozzle.
(4). Mount the hub brush, fix brush kit or soap bottle.
CAUTION: Never disconnect the high pressure hose
from the machine while the system is still pressurized .
To depressurize the unit, turn off the motor, turn off the
water supply and squeeze the trigger 2-3 times.
6.
When you finish your clean job turn the switch to "
OFF/O" position.
7.
Press the " test " button on the GFCI, and unplug the
power plug. This must be done each time the unit is in
maintenance.
8. Turn off the water supply.
9. After motor and water supply are turned off, trigger
spray gun to depressurize system.
10. Lock the trigger and put the spray gun into gun
holder, power cable to power cable hook and high
pressure hose to the hook. ( Fig 9)
40°nozzle - white
green
Turbo nozzle
OPERATING
Fig. 9
CAUTION: NEVER using pressure washer after water
supply is turned off. Serious damage could occur to
the pump and /or motor.
WARNING:NEVER disconnect high pressure
discharge hose from machine while system is
pressurized. To depressurize, turn motor off, turn
water supply off and squeeze gun trigger 2-3 times.
11. After each use, wipe all surfaces of the pressure
washer with a clean and damp cloth.
TO WASH WITH DETERGENT
1. Fill it with a properly formulated detergent or cleaner
with a water ratio according to instructions on the
container. Connect nozzle to lance.
2. Squeeze the trigger, and detergent will come out
through the detergent bottle nozzle.
3.Apply detergent so it thoroughly covers cleaning
surface.
4. Allow detergent to remain on the surface for a few
minutes. This is a good time to use a brush to lightly
scrub heavily soiled areas.
5. Change to spray nozzle to rinse detergent from
surface.
6. Cleaning up: always draw fresh water through the
detergent bottle when done to flush any remaining
detergents from the injection system. The bottle could be
detached if necessary during this process.
7
PW20502B
Publicidad
