Uline H-10768 Manual página 2

1. Start with the bottom shelf. Snap the interlocking
pieces of a shelf support (wide end down) around
the post at the lowest groove where shelf is to be
located. Slide the support up or down until it snaps
into the groove. Add a shelf support to the same
height on the remaining posts. (See Figure 3)
Figure 3
2. Slide posts through underside of shelf until shelf
slides firmly over supports. (See Figure 4)
Figure 4
3. Stand unit upright. Gently tap shelf down to secure it
using rubber mallet. (See Figure 5)
Figure 5
PAGE 2 OF 6
UNIT ASSEMBLY
4. Place shelf supports on each post, 6" above the
Shelf
Support
5. Repeat this process with the remaining box slides
6. Add shelf supports to very top of posts. Place top
1-800-295-5510
uline.com
bottom shelf to allow room for divider boxes. Slide
box slides onto posts on each side of shelving unit.
Gently tap box slides down to secure. (See Figure 6)
with 6" between each set of shelf supports.
shelf on shelf supports and gently tap with rubber
mallet. (See Figure 7)
Figure 7
Figure 6
0623 IH-10768