Technical Data; Work Area - Urrea USCS1 Manual De Usuario

E N G L I S H

1. TECHNICAL DATA

Viewing Field: 108 x 51 mm.
Shade Glass: Shade 11.
Operating Temperature:
-5 Cº to + 55 Cº.
Certificaciones y estándares:
CE EN175B; EN 166B; EN169.
Helmet material:
Polypropylene (Fire retardant).
Viewing window material: Nylon.
Total weight: 480 grs.
2. HELMET PARTS
1. Movil viewing window.
2. Headgear angle adjusting knobs.
3. Adjusting band head height.
4. Padded band.
5. Tilt adjustment.
6. Knob to adjust the size.
3. ASSEMBLY INSTRUCTIONS
REPLACING THE PROTECTION LENS
1. Ensure that the helmet is always fitted
with an outer and Inner protection
lens.
2. These protection lenses must be
replaced if
covered with welding spatter to the
4
broken, damaged
extent that vision is impaired.
3. Outer and Inner protection lenses are
consumables and must be replaced
regularly with genuine certified spare
parts..
HEADGEAR INSTALLATION
1. Install headgear by removing threaded
knobs (one at a time) and fasten again
after placing each threaded stud
through the larger holes on the sides
of the helmet.
2. Rotate the adjustment knob at the rear
of the headgear assembly to fit the
users head.

4. WORK AREA

•
Keep your work area clean and well lit.
•
Do not use electronic equipment in
explosive atmospheres, such as being
in the presence of flammable liquids,
gases or dust. Electrical products
generate sparks, which can cause fires.
5. TEAM USE AND CARE
•
Materials that may get in contact with
the wearers skin could cause Allergic
reactions to susceptible individuals.
•
Welding Helmets do not provide
or
unlimited eye, ear and face protection.
•
This Helmet is not suitable for laser