camry Premium CR 8061 Manual De Uso página 3

SAFETY CONDITIONS IMPORTANT INSTRUCTIONS ON SAFETY OF USE PLEASE READ CAREFULLY AND KEEP FOR
The warranty conditions are different, if the device is used for commercial purpose.
1.Before using the product please read carefully and always comply with the following instructions. The manufacturer is not
responsible for any damages due to any misuse.
2.The product is only to be used indoors. Do not use the product for any purpose that is not compatible with its application.
3.The applicable voltage is 220-240V, ~50/60Hz. For safety reasons it is not appropriate to connect multiple devices to one power
outlet.
4.Please be cautious when using around children. Do not let the children to play with the product. Do not let children or people
who do not know the device to use it without supervision.
5.WARNING: This device may be used by children over 8 years of age and persons with reduced physical, sensory or mental
capabilities, or persons without experience or knowledge of the device, only under the supervision of a person responsible for their
safety, or if they were instructed on the safe use of the device and are aware of the dangers associated with its operation. Children
should not play with the device. Cleaning and maintenance of the device should not be carried out by children, unless they are
over 8 years of age and these activities are carried out under supervision.
6.After you are finished using the product always remember to gently remove the plug from the power outlet holding the outlet with
your hand. Never pull the power cable!!!
7.Never put the power cable, the plug or the whole device into the water. Never expose the product to the atmospheric conditions
such as direct sun light or rain, etc.. Never use the product in humid conditions.
8.Periodically check the power cable condition. If the power cable is damaged the product should be turned to a professional
service location to be replaced in order to avoid hazardous situations.
9.Never use the product with a damaged power cable or if it was dropped or damaged in any other way or if it does not work
properly. Do not try to repair the defected product yourself because it can lead to electric shock. Always turn the damaged device
to a professional service location in order to repair it. All the repairs can be done only by authorized service professionals. The
repair that was done incorrectly can cause hazardous situations for the user.
10.Never put the product on or close to the hot or warm surfaces or the kitchen appliances like the electric oven or gas burner.
11.Never use the product close to combustibles.
12.Do not let cord hang over edge of counter or touch hot surfaces.
13.Never leave the product connected to the power source without supervision. Even when use is interrupted for a short time, turn
it off from the network, unplug the power.
14.In order to provide additional protection, it is recommended to install residue current device (RCD) in the power circuit, with
residual current rating not more than 30 mA. Contact professional electrician in this matter..
15. Do not leave the device plugged in without supervision.
16. Use only original factory accessories and spare parts which came with the cooler.
17. Use only original factory power cables or other cables recommended by the producer.
18. Do not overload the cooler. The lid has to close freely. Take caution as not to cover the fan from the inside of the cooler.
19. Use only in upright position.
20. Do not expose the cooler onto direct sunlight, snow, rain, excessive humidity etc.
21. Please take caution when transporting the device. Make sure the device won't fall over during transport.
22. Make sure that the vents have free space around them. Covering the vents will diminish the value and speed of cooling and
can lead to damaging the device.
23. Do not connect the device with the car charger and to the wall socket at the same time as it will damage the device.
Device description:
1A. Control Panel
2A. Mode select: Cooling/Heating
Using the device.
1. Make sure that the mode select on the control panel (1A) is set on off position (2A)
2. Please insert the other end of the power cable into the mains socket (depending what kind of energy source we have). For powering from two different power sources please use the appropriate
power cord.
3. Cooling: please move the switch(2A) to COLD position. Make sure to turn the speed select (2B) to either Eco or Max setting.
4. Heating: please move the switch (2A) to HOT position.
Cleaning and Maintenance
1. Before cleaning make cure that the device is not powered.
2. The cleaning process is restricted to using a damp cloth with a little of washing up liquid on the inside and outside of the devices body. DO NOT PUT ANY FOREIGN OBJECTS INTO THE
VENTS TO TRY AND CLEAN THEM.
3. Do not submerge or wet the device.
4. Do not use abrasive, rough or other such sponges, papers, cloths or towels as it may damage the device.
TECHNICAL DATA
Power source 220-240V ~50/60Hz
Power source 12V DC
Capacity: 45L
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. Used appliance should be delivered to the
dedicated collecting points due to hazarsous components, which may effect the environment. Do not dispose this appliance in the common waste bin.
FUTURE REFERENCE
1B. Vent
2B. Speed Select: Eco/Max
Power: Cooling: 58W Heating:52W
Power: Cooling: 48W Heating:40W
ENGLISH
1C.Car power adapter
3
1D. mains power adapter