Publicidad
Idiomas disponibles
Idiomas disponibles
FITTING INSTRUCTIONS -
TOWBAR
Type (Westfalia):
D-Value:
Max. vertical coupling load towbar:
Max. vertical coupling load on vehicle: 80kg
Manufacturer:
Model Application:
Approval no. as
per Guideline:
A50-X
General information:
The vehicle manufacturer's specifications
regarding trailer load and nose weight are
decisive for driving, and the values specified for
the towing hitch must not be exceeded.
Formula for D-value:
Trailer load [kg] x vehicle total weight [kg]
Trailer load [kg] + vehicle total weight [kg]
The towing hitch serves for towing trailers fitted
with ball couplings and for use with load carriers
approved for attachment to the towing hitch.
Any use other than that specified is prohibited.
Driving with a trailer must be adapted to the
road conditions. The vehicle's handling is
affected when a trailer is being towed. Follow
the vehicle manufacturer's instructions.
The fixing points specified as standard must be
observed.
National guidelines concerning official
approval of auxiliaries must be observed.
These installation and operating instructions
must be enclosed with the vehicle papers.
335 417
10,9kN
80kg
Westfalia-Automotive
GmbH
Am Sandberg 45
D-33378 Rheda-
Wiedenbrück
RAV4
E13 55 R-01 3551
9,81
x
= D [kN]
1000
Installation instructions:
The towing hitch is a safety component and
must only be installed by qualified personnel.
Any alteration or conversion to the towing hitch
is prohibited, and would lead to cancellation of
design certification.
Remove insulating compound and underseal
from vehicle (if present) in the area of the
mating surfaces of the towing hitch. Seal any
bare bodywork and bores with anti-corrosive
paint.
Operating instructions:
Again tighten all securing bolts of the towing
hitch after approx. 1000 trailer km, observing
specified tightening torques.
The towing hitch must be kept clean and
greased. However, if a stabilisation device, e.g.
Westfalia "SSK", is used, the towing hitch must
be free from grease. Follow the instructions in
the relevant operating instructions.
As soon as the towing hitch diameter is 49.0
mm or less at any point, it must no longer be
used for safety reasons.
After the towing hitch is fitted, the empty weight
of the vehicle increases by 37,2kg.
Apply corrosion protection material as specified
in the Toyota service guidlines, where
necessary.
In order to use the trailer hitch, simultaneous
installation of an electrical kit is required.
(Cable set not included!)
Manual Ref.nr.: AIM 003 046 - 0
Subject to alteration.
3
Publicidad
